Skip to main content

Easy ways to install mirrors

Adhesive tapes for easy installation

Looking to install mirrors instantly? Then look no further than Saint-Gobain Glassmate Double Sided Tape!

USPs

With a thickness of 1.5 mm, width 24 mm and length 5m, the SGG Glassmate Double Sided Adhesive Tape is distinct for its Instant Fixing | High Durability | UV Resistance | High Bond Strength | High Peel Strength | Green Features

Glassmate Double Sided Tape vs Other Tapes in the market

Parameter Glassmate Other branded tapes
Foam Type Polyethylene (PE) Polyurethane (PU)/ Acrylic
UV Resistance Yes (does not yellow) No (tendency to yellow over time)
Bond strength 250 kPa 100 – 220 kPa
Thickness 1.5 mm 0.9 – 1.5 mm
Compressibility Low(maintains thickness even after glass installation) High(compresses after glass installation)

Key Features

Odour-free

Support time: 10 minutes

High bond strength

High peel strength

High shear strength

Polyethylene foam for higher durability

Works at high temperatures

Lower foam compression to accommodate substrate undulations

UV resistant

VOC compliant

Applications

SGG Glassmate Double Sided Adhesive Tape can be used in the installation of SGG Mirror | SGG Planilaque strong | SGG Planilaque silk | -(don’t think this exist anymore) | SGG Planilaque Evolution

Recommended substrates

Mirror

Lacquered Glass

Toughened Glass

Plywood

MDF Board

How to use

Step 1

Using a smooth cloth (lint-free), wipe the surfaces (plywood and the paint side of the glass) to remove dust and contamination.

Step 2

With an equal mix of IPA (Iso-phrophyl Alcohol) and water, clean the surface of glass and substrate thoroughly.

Step 3

With SGG GLASSMATE Primer, wipe the surface of glass and substrate thoroughly. Allow it to dry for 2 minutes.

Step 4

Follow it up by applying SGG GLASSMATE Tape on the paint side of the glass with the blue liner facing up. Apply uniform pressure.

Step 5

From the edge, peel and bend 2” of liner.

Step 6

Once the liner has been completely removed, the glass is ready for installation.

Step 7

Align the edges and stick liner to the substrate (plywood).

Step 8

Applying uniform pressure, hold for 10 minutes on the glass to initiate the bond.

For calculating the consumption of Tape/Primer required for different dimensions of glass, please do refer to the SGG GLASSMATE calculator; It is available on our website, on request.